The folllowing instructions come with no warranty or guarantee, improper assembly or proper or using of excessive force may result in damage to the parts involved or to your PDA/MP3 Player.
By utilizing these instructions, you agree to hold Global-Batteries blameless and unaccountable for damages or problems caused by use of these instructions. These instruction require a moderate level of technical ability and proficiency in the use of hand tools, as well as a general understanding of electronic components. Buyer assumes full responsibility for the installation of this replacement battery.
 |
Install Replacement Battery Step 1:
Measure down the right or left seam of the iPod 6cm (60mm).
This is the point to begin prying the case. At this point, insert the included screwdriver and begin to pry open the case, working back and forth along the seam. |
 |
Install Replacement Battery Step 2:
Once the side you are working on pops loose, work your way around the iPod, unclipping the clips from the silver case by pushing the towards the center of the iPod. Once the silver case comes loose, it should still be attached by a ribbon cable. |
 |
Install Replacement Battery Step 3:
Once you have access to the inside of the iPod you will notice the hard drive surrounded by blue rubber. Remove the hard drive by lifting all the blue rubber. At the base of the rubber you will see a small ribbon cable tab that connects the hard drive to the motherboard. Gently lift this tab and disconnect the hard drive. Place the hard drive aside for re-assembly. |
 |
Install Replacement Battery Step 4:
To remove the battery, lift the battery from its compartment using the included screwdriver. You will notice the power cable is wrapped under a portion of the green motherboard. Carefully pull the power cord out from under the motherboard, you can use the screwdriver to assist you. |
 |
Install Replacement Battery Step 5:
Using your fingers, gently disconnect the battery by gently pulling on the power connector. The battery should now be free from the unit and the replacement battery can be plugged in. |
 |
Install Replacement Battery Step 6:
Remember to wrap the power cord back under the motherboard before applying the battery within the case (use the screwdriver to push it back in). Reconnect the hard drive by placing the hard drive connector over the socket in the motherboard and push it in. Verify the connection by gently pulling on the hard drive. Place the hard drive back into position and snap the silver metal case back together. Your new battery is now ready for charging.
Your new battery will need to be charged before first use. |
|
